Sök

Din avgränsning ger 16 träffar.

• 2004:56 Whiskers and Localized Corrosion on Copper in Repository Environment (pdf 2 MB)

  01 januari 2004

  2090 kB ... bleed system also was active. The volume was 25 dm3. The feed and bleed flow to the vessel was ≈ 2 ml/min and the system was kept at ambient pressure and temperature. The solution composition accounted...

  Innehållstyp: Dokument

• 2004:15 Omgivningskontrollprogram för de kärntekniska anläggningarna, revision

  01 december 2004

  1599 kB ... or- ganiska substansen. ALGER (inklusive påväxtprov) VÅTVIKTSBESTÄMNING Låt droppa av i 30 min. Provet vägs i färskt eller halvtinat tillstånd. TORRVIKTSBESTÄMNING Frystorkas eller torkas till...

  Innehållstyp: Dokument

• 2004:52 Phenomenological Studies on Melt-Structure-Water Interactions (MSWI) during Postulated Severe Accidents

  01 januari 2004

  1788 kB ... boundary layer thickness. Brenner et al. proposed to define this quantity as ⎟⎟⎠ ⎞ ⎜⎜⎝ ⎛= n R w 2 ,min νδ (4.19) in which w is the frequency of the sound driving the radial oscillations. The quantity...

  Innehållstyp: Dokument

• 2004:12 Transparency, Citizen Participation, Organisations and Roles (pdf 1.66 MB)

  01 januari 2004

  1696 kB ... Scientist, SKi SKB Ski, SSI Swedish Nuclear Waste Management System Ministries, Parliament Min. Res, ANDRA, CEA, IPSN, GPD, CNE, OPECST DSIN (DIN) OPRI Standards for w aste separation, conditioning...

  Innehållstyp: Dokument

• 2004:26 Engineered Barrier System - Manufacturing, Testing and Quality Assurance (pdf 324 kB)

  01 januari 2004

  324 kB ... criteria have not been developed yet. An upper limit of the inflow 18 rate (less than 10 l/min) has been suggested (Andersson et al., 2000), but there is no information about the necessity or relevance...

  Innehållstyp: Dokument

• 2004:51 Investigation of the Potential for In-Vessel Melt Retention in the Lower Head of a BWR by Cooling through the Control Rod Guide Tubes

  01 januari 2004

  1437 kB ... was switched on. The power input to the bed was increased in small steps. Delays of at least 1.5 min were necessary, after a power step, to make reasonable power measurements. Near the expected dryout...

  Innehållstyp: Dokument