Sök

Din avgränsning ger 19 träffar.

• 2012:44 Technical Note, Review of Matrix Diffusion and related properties of intact rock in SKB’s Licence Application for a Spent Nuclear Fuel Repository in Forsmark, Sweden

  12 september 2012

  den modell som SKB företrädesvis använder har utökats väsentligt under de senaste 10 åren. Enligt min uppfattning saknas dock entydiga bevis för obegränsad matrisdiusion. Jag rekommenderar ytterligare ... and other supporting documents Reviewed report Reviewed sections Comments SKB TR-11-01, SR-Site min report. Long-term safety for the final repository for spent nuclear fuel at Forsmark Sections...

  Innehållstyp: Dokument

• 2012:17 Technical Note, Corrosion of copper canister

  20 juni 2012

  inflow is less than 0.01 l/min in 99.9% of the deposition holes in Forsmark, see SKB TR-06-102. Assume that some deposition holes will experience half that inflow rate, 0.005 l/min. This corresponds to an ... feature is the pinning effect of the entrapped oxide particles. After annealing the samples for 30 min at 850 °C, the general grain size was considerably larger, but the grains near the entrapped oxide...

  Innehållstyp: Dokument

• 2012:07 Implementation of the Master Curve method in ProSACC

  22 mars 2012

  902 kB ... probability has the form: (4) . exp1 4 min0 min                  KK KK P Jcf Here, the Weibull distribution...

  Innehållstyp: Dokument

• 2012:71 Identification of Brittle Deformation Zones and Weakness Zones

  20 december 2012

  affected by the geolog- ic evolution since the structures were formed. Precipitation of fracture min- eral and weathering of fracture walls and fills are example of processes that decreases the water ... zones (Chapter 4) according to the applied definition of zones. This step need also, except from the min- imum magnitude of fracture frequencies in core and damage zones, guidance regarding how to locate...

  Innehållstyp: Dokument

• 2012:39 Technical Note, Review of Engineering Geology and Rock Engineering aspects of the construction of a KBS-3 repository at the Forsmark site – Initial Review Phase

  06 september 2012

  2744 kB ... bearing. R-08-116 notes that the expected inflows into the various excavations will exceed the 10 ℓ/min per 100 m length set for the shafts and ramp (R-07-33, p. 51). A pilot grouting programme is planned...

  Innehållstyp: Dokument

• 2012:25 Workshop on Seismology

  23 augusti 2012

  2395 kB ... thousands of years. Therefore, the results pre- sented by Rutqvist and Tsang (2008) and later by Min and Stephansson (2009) and Lee et al. (2010) shows that the shear stress increases more during thermal...

  Innehållstyp: Dokument

• 2012:14 Rapport från SSM:s vetenskapliga råd om ultraviolett strålning 2011

  14 juni 2012

  1292 kB ... Martschin C, Wiegleb-Edström D, Wiklund K. Previous extensive sun exposure and subsequent vita- min D production in patients with basal cell carcinoma of the skin, SSM 2012:14 24 has no protective...

  Innehållstyp: Dokument

• 2012:02 Evaluation of activity build-up experiments

  20 januari 2012

  1851 kB ... monitored by their weight injected. From the weight loss of the prepared solution a dosage flow (ml/min) was calculated. This was done since the pumps (HPLC) could be unstable 1 . In Figure 3 the injection...

  Innehållstyp: Dokument

• 2012:18 Technical Note, SR-Site Independent Modelling of Engineered Barrier Evolution and Coupled THMC: Contribution to the Initial Review Phase

  25 juni 2012

  5043 kB ... 158, para 2 of TR-11-01 it is stated that the total inflow to a deposition hole must be <0.1 L/min, but it is unclear when and how the actual inflow would be determined. Presumably, this inflow...

  Innehållstyp: Dokument