Din avgränsning ger 114 träffar.
-
2022:14 Weld residual stress and strain measurements on a mock-up with single layer strip cladding common in reactor pressure vessels
SSM perspektiv Bakgrund Reaktortryckkärl tillverkas vanligtvis av låglegerade ferritiska stål som på insidan beläggs med ett eller flera lager av rostfritt stål, så kallad plätering eller på engelska cladding. Den rostfria pläteringen påverkar...
Innehållstyp: Publikationer -
2022:11 Kingdom of Sweden IRRS ARM Summary Report 2022
The IAEA Integrated Regulatory Review Service Mission to Sweden in November 2022...
Innehållstyp: Publikationer -
2022:09 Assessment of modelling approaches for axial gas flow inside LWR fuel rods
SSM perspective Background The fuel rod analysis program SCANAIR has been developed by IRSN (Institut de Radioprotection et de Sûreté Nucléaire) for analysis of reactivity initiated accidents (RIA) in light water reactors. The Swedish Radiation Safety Authority (SSM) has...
Innehållstyp: Publikationer -
2022:04 Warm Pre-Stressing mechanisms
SSM perspective Background Swedish nuclear power plants (NPP) were originally designed and analyzed with an assumed operating period of approximately 40 years. As Swedish NPPs reach their original technical design life the safety of the additional operating time has to be verified. With...
Innehållstyp: Publikationer -
2022:03 Effect of Neutron Irradiation on the Oxidation and Corrosion of Austenitic Stainless Steels
SSM perspective Background Reactor pressure vessel internal components of austenitic stainless steel located close to the core are subject to a high neutron flux. Irradiation by fast neutrons induces changes in the material that affect microstructure, mechanical properties and microchemistry.
Innehållstyp: Publikationer -
2021:20 Effects of additives on UO2 fuel behavior: expanded edition
SSM perspective Background The Swedish Radiation Safety Authority (SSM) follows the development of nuclear fuel closely. Fuel with additives like chromia and gadolinia is used in Swedish reactors and fuel with even better thermal and mechanical properties is under development. This project is...
Innehållstyp: Publikationer -
2021:10 Establishment and use of attention values in environmental fatigue assessments
SSM perspective Background As Swedish NPPs reach their original technical design life, re-assessment of the fatigue life of structural components is needed for safe long term operation (LTO). In these re-assessments one must consider that new knowledge has shown that environmental effects on...
Innehållstyp: Publikationer -
2021:09 Mechanisms important for material modelling in weld residual stress analysis
SSM perspective Background The prediction of weld residual stresses (WRS) is very complex as many mechanisms and phenomena influence the development of WRS during welding. For accurate prediction, the constitutive material models used are essential and must be able to describe the material...
Innehållstyp: Publikationer -
2021:05 Cladding tube rupture under LOCA: Data and models for rupture opening size
SSM perspective Background The Swedish Radiation Safety Authority (SSM) follows the research on fuel performance closely. One aspect that is currently being studied in several research projects is the risk of release of fragmented fuel into the primary coolant in case of an accident. This risk...
Innehållstyp: Publikationer -
2021:04 Calibration of models for cladding tube high-temperature creep and rupture in the FRAPTRAN-QT-1.5 program
SSM perspective Background The Swedish Radiation Safety Authority (SSM) follows the research on fuel performance closely. One aspect that is currently being studied in several research projects is the risk of release of fragmented fuel into the primary coolant in case of an accident. This risk...
Innehållstyp: Publikationer