Sök

Visar 2694 sökträffar på ”SSMFS 2012:1”

Sortera på:

Relevans Datum
  • 2013:04 Research and Development Program in Reactor Diagnostics and Monitoring with Neutron Noise Methods, Stage 18

    Background Objectives of the project Results Project information Report: 2013:04 Contents Summary 1. Application of CoreSim with a two-dimensional model of vibrating fuelassemblies, for the calculation ... simulate bubbly two-phase flow withaxially dependent void fraction and void velocity Sammanfattning 1. Tillämpning av brussimulatorn CoreSim för att beräkna bruset från vibrerandebränsleknippen i ”ex-core”...

    Innehållstyp: Dokument
  • 1993:11 Methods for determination of strontium -90 in food and environmental samples by Cerenkov counting

    dryness and ashed. Environmental and food samples are oven dried and ashed. The ash is dissolved in 1 molar hydrochloric acid and, at pH 1.0-1.2 the yttrium-90 is extracted from the solution with 10% HDEHP ... into 3 molar nitric acid and precipitated as hydroxide. The hydroxide precipitation is dissolved in 1 ml conc nitric acid, transferred to a liquid scintillation vial and the Cerenkov radiation from yttrium-90...

    Innehållstyp: Dokument
  • 2017:18 FEM analysis of the mechanical integrity for the canister intended for storage of spent nuclear fuel with regard to copper creep ductility

    vital importance. It has been shown that creep ductility for oxygen free copper can be very low (< 1 %). SKB has for this reason proposed to use oxygen free copper alloyed with small amounts of phosphorous ... criteria and postulated material behavior. Results show a required creep ductility in the range of 1% to 10%. It is concluded that the method used for this analysis is quite sensitive to several parameters...

    Innehållstyp: Dokument
  • SSM Report 2008:01 A combined deterministic and probabilistic procedure for safety assessment of components with cracks – Handbook

    ...............................................................................................8 1. INTRODUCTION...................................................................................... ... a cylindrical bar c Constant in algorithm to calculate the most probable point of failure (MPP) 1 2,c c Constants in the distribution function - Probability Of Detection ic Constants in fitting...

    Innehållstyp: Dokument
  • 2006:36 Mechanical Integrity of Canisters Using a Fracture Mechanics Approach

    combined boundary element (BEM) and finite element (FEM) methods. The objectives of the project are: 1) to investigate the possibility of initiation and growth of fractures in the cast-iron canisters under ... new fractures or growth of existing fractures (defects) are very small, due to the reasons that: 1) the canisters are under mainly compressive stresses; 2) the induced tensile stress regions are too...

    Innehållstyp: Dokument
  • 2006:24 Crack Characterisation for In-service Inspection Planning An Update

    between 20 and 100 times has been used with a typical value of 50. The measuring length used has been 1-2 mm. In comparing the crack morphology values in this report with other published results, this information ... Sammanfattning ......................................................................................... 9 1 Introduction .................................................................................... 11...

    Innehållstyp: Dokument
  • 2006:30 Benchmarking – a validation of UTDefect

    173 kB ... coincide with those of the SKI. Table of content SUMMARY i SAMMANFATTNING ii INTRODUCTION 1 PROBE MODELLING 2 CALIBRATION 5 COMPARISON WITH EXPERIMENTAL DATA 6 Side-drilled hole ... not included in UTDefect so part of the present project is to make these extensions of UTDefect. 1 Probe modeling The transducers used in the benchmark study are of immersion type and both planar...

    Innehållstyp: Dokument
  • 98:28 Study of the Possibility of Localising a Channel Instability in Forsmark-1

    Study of Channe J the Possibility of Localising a l Instability in Forsmark-1 . K-H. Karlsson and I. Pázsit Department of Reactor Physics Chalmers University of Technology Göteborg 1998 Undersö ... lokalisera kanalinstabilitet i Forsmark-1 J. K-H. Karlsson och I. Pázsit ers Tekniska Högskola, Avd. för Reaktorfysik 412 96 Göteborg Sammanfattning Forsmark-1, efter revision 1996, uppträdde en speciell...

    Innehållstyp: Dokument
  • Poddavsnitt 32: Den svenska linjen går i graven - Strålsäkerhetens historia del 4

    kommande kärnkraftverken. Först var det ju hela Marviken-gänget, sedan var det O1, O2 och Ringhals 1 som gick och utbildade sig hos oss, både ledningen och driftpersonalen så att säga, som gick på skift ... ni fick igång den där i hösten -68 men sedan hände det någonting -69 också väl? – Ja det gjorde det. 1 maj 69 så blev jag uppringd och då hade det hänt någonting ute i kyltornen. Det hade rasat ner en jäkla...

  • 2008:57 Discrete Feature Model (DFM) User Documentation

    the author/authors and do not necessarily coincide with those of the SKI. Table of Contents 1 Introduction....................................................................................... ... dfm table tfunctions (disabled feature)...........................................................83 1 6 meshtrkr particle-tracking module.............................................................

    Innehållstyp: Dokument